This information stand clearly displays information or directions on a solid stable base with an overall height of 39 inches. These come ready to add a signage plate, no adapter needed.
Standard sized displays are 8 1/2" x 11", 11" x 14", and 11" x 17". These can be used in portrait or landscape formats. 

The MS-1185SP has the end strips on the 11" sides and the MS-8511SP has the end strips on the 8.5" sides. The MS-1185SP can be used in both landscape and portrait positions using the set screw on the info stand. The MS-8511SP should only be used in the landscape position as it will be off center if used in the portrait position.


!!!*** SIGNAGE PLATE SOLD SEPARATELY ***!!! -These must be used with one of the available signage plates.

I wanted to say I was very pleased with all of the items. Everything came as promised and on time. Most of all, I was extremely pleased with your customer service skills. You helped make this order a smooth and successful one for us, and I truly appreciate all of your efforts. I work with a lot of vendors on a day to day basis, and you are by far one of the best I have worked with. Thank you for going beyond our expectations. I will make sure to keep you in mind for any future purchases we may make. Thanks again for everything! - Boston Properties

INSTALLATION INSTRUCTIONS

1. Assemble the Information Stand by placing the stainless steel cover over the heavy black baseplate.
2. Remove the bolt from the end of the upright, fit the washer onto the bolt and place it through the central hole of the base plate and cover and into the end of the upright. Tighten securely with the Allen Key provided.
3. Using a phillips head screw driver, remove one of the end caps from the signage plate and slide onto the angled square on the top of the upright so that it engages in the slots on the back of the signage plate. When central, lock in place by tightening the small set screw from the rear.
4. Slide the acrylic cover out, remove the protective film.. from both sides!.. slide your artwork in and replace the cover. Screw the end cap back into position.

MS-A1185SP - 11" x 8.5" Signage Plate

MS-A8511SP - 8.5" x 11" Signage Plate

MS-A8514SP - 8.5" x 14" Signage Plate

MS-A1114SP - 11" x 14" Signage Plate

MS-A1117SP - 11" x 17" Signage Plate

MS-A1624SP - 16" x 24" Signage Plate

MS-WB60- 60 Degree Wall Bracket

1 x Upright with Fixed Signage adaptor

1 x Base
1 x Base Cover
1 x Connecting Bolt
1 x Allen Key

* Buy signage plates separately

http://museumdisplay.com

http://museumbarriers.com